Grand Caravan FWD V6-3.3L VIN 3 Flex Fuel (2002)
3. Using a thin wall socket, remove special nut retaining sensor to wheel.
4. Remove sensor from wheel.
INSTALLATION
NOTE: Before reinstalling a tire pressure sensor, replace sealing grommet at base of valve stem.
1. Wipe area clean where sensor sealing grommet contacts wheel. Make sure surface of wheel is not damaged.
2. Install sensor in wheel as shown. Do not attempt to mount sensor otherwise, damage may occur.
3. Using a thin wall socket, install special sensor nut. Tighten nut to 4 Nm (35 in. lbs.) torque.
CAUTION: Over-torquing the sensor nut by as little as 12 Nm (106 in. lbs.) may result in sensor separation from the valve stem. Under this condition,
the sensor may still function, however, the condition should be corrected immediately.
4. Mount tire on wheel following tire changer manufacturers instructions, paying special attention to the following to avoid damaging tire pressure
sensor:
a. Rotating Wheel Tire Changers - Once the wheel is mounted to the changer, position the sensor valve stem approximately 210° from the head
of the changer in a clockwise direction before rotating the wheel (also in a clockwise direction) to mount the tire. Use this procedure on both
the upper and lower tire beads.
