Grand Caravan FWD V6-3.3L VIN 3 Flex Fuel (2002)
low speed mode will be provided.
PARK AFTER IGNITION OFF
Because the wiper relays are powered from the battery, the CM can run the wipers to park after the ignition is turned off.
WIPE AFTER WASH
When the river presses the wash button for over 0.5 seconds an releases it, the wiper will continue to run for 2 additional wipe cycles.
REAR WIPER
The rear wiper/washer system consists of the following features: mist wipers, intermittent wipers and wipe after wash. The rear wiper system is only
active when the ignition switch is in the RUN/ACC position. The vehicle operator selects the rear wiper function using one of the three buttons on the
dash mounted rear wiper switch. The rear wiper switch is hardwired to the Body Control Module (BCM). Upon receiving a wiper switch signal, the
BCM provides 12 volts to the rear wiper motor. Rear washer occurs when the BCM receives a rear washer switch ON input. The BCM sends a PCI
Bus message to the FCM requesting rear washer on. The FCM activates the rear washer by providing a ground for the rear washer motor.
SPEED SENSITIVE INTERMITTENT WIPE MODE
The delay setting of the rear wiper system is based solely on the vehicle speed. The delay time is defined as the amount of time from the start of a wipe
to the beginning of the next wipe. The rear wiper system delay time is based on the following: 7.75 - (MPH x 0.05) = Seconds delay
Examples:
At zero (0) MPH the delay is 7.75 seconds.
At 100 MPH the delay is 2.75 seconds.
WIPE AFTER WASH
When the driver presses the wash button for over 1.5 seconds and releases it, the wiper will continue to run for 2 additional wipe cycles.
