Grand Caravan FWD V6-3.3L VIN 3 Flex Fuel (2002)
9.
Monitor the "Flash Download/Update Progress" window on the TechCONNECT and follow the instructions on TechCONNECT. When the flash
process is complete, proceed to Step # 10.
10.
Disconnect the DRBIII(R) from TechCONNECT.
11.
Open the hood, install a battery charger and verify that charging rate provides approximately 13.5 volts.
12.
Connect the DRBIII(R) to the vehicle.
13.
Download the flash from the DRBIII(R) to the vehicle. Using the DRBIII(R) select:
a.
"Vehicle Flash"
b.
Follow the directions on the DRBIII(R) screen. When the flash process is complete, proceed to Step # 14.
NOTE:
Due to the TCM programming procedure, a DTC may be set in other modules (PCM, BCM, MIC, SKIM, etc.) within the vehicle, if so equipped.
Some DTC's may cause the MIL to illuminate. Check all modules using "Module Scan", record the DTC's, and erase these DTC's prior to returning
the vehicle to the customer. Erase any DTC's in the PCM only after all other modules have had their DTC's erased.
14.
With the DRBIII(R) perform the TCM Quicklearn procedure.
NOTE:
The following step is required by law.
15. Type the necessary information on the "Authorized Modification Label" p/n 04275086AB and attach near the VECI label. (Fig. 1)
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
