Grand Caravan FWD V6-3.3L VIN 3 Flex Fuel (2002)
Camshaft Position Sensor: Service and Repair
REMOVAL
1. Disconnect the negative battery cable.
Fig.5 Air Box Cover
2. Remove the air box cover and inlet tube.
Fig.6 Camshaft Position Sensor
3. Disconnect camshaft position sensor electrical connector from the wiring harness connector.
4. Remove bolt holding sensor.
5. Rotate sensor away from block.
6. Pull sensor up out of the chain case cover. Do not pull on the sensor wiring. There is an O-ring on the body of the sensor. The O-ring may make
removal difficult. A light tap to top of sensor prior to removal may reduce force needed for removal.
