Grand Caravan FWD V6-3.3L VIN 3 Flex Fuel (2002)
Wiper Control Module: Service and Repair
REMOVAL
1. Release the hood latch and open hood.
2. Disconnect and isolate the battery negative cable.
3. Remove the wiper arms.
4. Remove the cowl cover.
Fig.8 Wiper Module Wire Connector
5. Disconnect the positive lock on the wiper module wire connector.
6. Disconnect the wiper module wire connector from the engine compartment wire harness.
7. Disconnect the windshield washer hose from coupling outside the module.
8. Disconnect the drain tubes from nipples on bottom of the wiper module.
9. Remove nuts holding wiper module to lower windshield fence.
Fig.9 Wiper Module
10. Remove bolts holding the wiper module to the dash panel.
11. Lift wiper module from weld-studs on lower windshield fence.
CAUTION: Do not allow wiper module to rest on brake master cylinder reservoir, damage to brake system can result.
