Grand Caravan FWD V6-3.3L VIN 3 Flex Fuel (2002)
Be sure that the hose clamps are installed on the hose past the upset bead on the tubes.
10.
Lower the vehicle until the wheels are just off the ground.
11.
Fill the power steering reservoir to the proper level with Mopar ATF+4 (MS-9602) (P/N 05013457AA) and then let the fluid settle for at least two
(2) minutes.
CAUTION:
Use only Mopar Automatic Transmission Fluid in the power steering system. Do not use other power steering fluids.
12.
Start the engine and let it run for a few seconds and then turn the engine off.
13.
Check the power steering fluid level and add fluid if necessary.
14.
Repeat Steps 11 through 13 until the fluid level remains constant after running the engine.
15.
Start the engine and then slowly turn the steering wheel from "lock-to-lock" eight times.
16.
Turn off the engine.
17.
Check the power steering fluid level and adjust as necessary.
18.
Lower the vehicle completely.
19.
Start the engine and then slowly turn the steering wheel from "lock-to-lock" eight times.
20.
Turn off the engine.
21.
Check the power steering fluid level and adjust as necessary.
