Grand Caravan FWD V6-3.3L VIN 3 Flex Fuel (2002)
9.
Locate the bracket connecting the power steering return line cooler loop to the cradle reinforcement plate (Fig. 1).
10.
Remove the fasteners connecting the cooler line to the reinforcement plate. Save the fasteners for use in Step # 17.
11.
Locate the bracket connecting the power steering pressure line to the cradle reinforcement plate (Fig. 1).
12.
Remove the fastener connecting the bracket to the reinforcement plate. Save the fastener for use in Step # 18.
13.
Remove and discard the J/U nut clip on the bracket.
14.
Locate and unscrew the tube nut connecting the power steering return line to the steering gear pinion housing.
NOTE:
The tube nut will remain loosely assembled to the power steering return line.
15.
Drain the remaining fluid into an appropriate container and discard the loop cooler line that was removed from the vehicle.
NOTE:
This fluid should not be reused to avoid introducing contamination from the container.
16.
Install the new power steering return line, p/n 04743473AE. Attach the power steering return line tube nut to the steering gear pinion housing and
tighten to 27.1 - 35.0 Nm (240 - 310 in. lbs.).
