dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Pinion Factor Setting|Page 5433 > < Pinion Factor Setting|Page 5431
Page 1
background image

Control Module: Service and Repair
Transmission Control Module Replacement

REMOVAL

NOTE:  If transmission control module is being replaced with a new or replacement unit, the Pinion Factor and Quick Learn procedures must be
performed. (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES/TRANSMISSION CONTROL MODULE - STANDARD
PROCEDURE) (Refer to ELECTRICAL/ELECTRON IC CONTROL MODULES/ TRANSMISSION CONTROL MODULE - STANDARD
PROCEDURE).

1. Disconnect battery negative cable.
2. Raise vehicle on hoist.
3. Remove left front tire/wheel assembly.
4. Pull back splash shield to gain access to TCM location.

Fig.16 Transmission Control Module 60-Way Connector

5. Disconnect TCM 60-way connector (Fig. 16).

Fig.17 Transmission Control Module Removal/Installation

Pinion Factor Setting|Page 5433 > < Pinion Factor Setting|Page 5431