dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Trunk / Liftgate > < Sliding Door Handle|Service and Repair
Page 1
background image

Hood Sensor/Switch (For Alarm): Service and Repair

REMOVAL

1. Release the hood latch and open the hood.

Negative Battery Cable

2. Disconnect and isolate the battery negative cable.
3. Using a small flat blade screws driver, pry trigger switch from top of the radiator closure panel.
4. Disconnect the trigger switch from the wire connector and remove the switch.

INSTALLATION

For installation, reverse the above procedure.

Trunk / Liftgate > < Sliding Door Handle|Service and Repair