Grand Caravan FWD V6-3.8L VIN L (2001)
13.
Remove the park brake cable from adapter by using a 1/2" wrench slipped over the park brake cable retainer as show in (Fig. 5) to compress the
locking tabs on the park brake cable retainer.
14.
Remove the disc brake caliper to adapter guide pin bolts.
15.
Remove caliper from the adapter using the following procedure:
a.
Rotate rear of caliper up.
b.
Pull the front of the caliper and the outboard brake shoe anti-rattle clip out from under the front abutment on the adapter.
16.
Support the caliper to prevent the weight of the caliper from damaging the flexible brake hose.
17.
Remove the rotor from the hub/bearing.
18.
Remove the four hub/bearing to axle mounting bolts.
CAUTION:
CORROSION MAY OCCUR BETWEEN THE HUB/BEARING AND THE AXLE. IF THIS OCCURS THE HUB/BEARING WILL BE
DIFFICULT TO REMOVE FROM THE AXLE. IF THE HUB/BEARING WILL NOT COME OUT OF THE AXLE BY PULLING ON IT BY
HAND, DO NOT POUND ON THE HUB/BEARING WILL DAMAGE THE HUB/BEARING. TO REMOVE A HUB/BEARING WHICH IS
CORRODED TO THE AXLE, LIGHTLY TAP ON THE DISC BRAKE CALIPER ADAPTER USING A SOFT FACE HAMMER. THIS WILL
REMOVE BOTH THE DISC BRAKE CALIPER ADAPTER AND THE HUB/BEARING FROM THE AXLE. THE HUB/BEARING WILL
THEN NEED TO BE REMOVED FROM THE CALIPER ADAPTER.
19.
Remove the hub/bearing from the axle.
