Grand Caravan FWD V6-3.8L VIN L (2001)
31.
Using Gauge, Brake Shoe, Special Tool C-3919 or an equivalent, adjust the rear park brake shoe to park brake drum clearance.
32.
Install rotor on hub/bearing.
33.
Carefully lower the disc brake caliper and brake shoes over the rotor and onto the caliper adapter by reversing the removal procedure in step 15.
CAUTION:
WHEN INSTALLING THE GUIDE PIN BOLTS, EXTREME CAUTION SHOULD BE TAKEN NOT TO CROSS-THREAD THE CALIPER
GUIDE PIN BOLTS.
34.
Apply brake grease p/n J8993704 to caliper guide pin bolts and install caliper guide pin bolts. Torque to 22 Nm (192 in. lbs.).
35.
Clean all foreign material off the threads of the outer C/V joint stub shaft. Install the washer and hub nut on the stub shaft of the outer C/V joint.
36.
Remove the locking pliers from the park brake cable (Fig. 4) and lower the vehicle.
37.
Set the parking brake. This is required to keep the driveshaft from rotating when tightening and torquing the hub nut and driveshaft inner joint to
driveline module mounting bolts.
38.
Raise the vehicle.
39.
Tighten the driveshaft inner joint to driveline module output shaft mounting bolts (Fig. 2) to a torque of 61 Nm (45 ft. lbs.).
40.
Tighten the outer C/V joint hub nut to a torque of 244 Nm (180 ft. lbs.).
41.
Install the spring washer, nut retainer and a new cotter pin on the stub shaft of the outer C/V joint.
42.
Install tire and wheel assembly.
43.
Tighten wheel mounting stud nuts in a crisscross sequence until all nuts are torqued to half specification. Then repeat the tighten sequence to full
torque of 135 Nm (100 ft. lbs.).
44.
Replace the left rear adapter using steps 2 through 43.
45.
Lower the vehicle.
46.
Fully apply and release the park brake pedal one time. This will seat and correctly adjust the park brake cables.
CAUTION:
BEFORE MOVING THE VEHICLE, PUMP THE BRAKE PEDAL SEVERAL TIMES TO INSURE THE VEHICLE HAS A FIRM BRAKE
PEDAL TO ADEQUATELY STOP THE VEHICLE.
