Grand Caravan FWD V6-3.8L VIN L (2001)
3. Place the shock absorber upper mounting eye in the Receiver so the notch in the Receiver clears the shock absorber body.
4. Tighten the screw drive until the Driver contacts the outer circumference of the bushing evenly. Continue to tighten the screw drive until the
bushing is pressed completely out of the shock absorber eye and into the Receiver.
5. Back off the screw drive and remove the bushing from the Receiver.
ASSEMBLY-SHOCK ABSORBER (UPPER BUSHING)
1. Install the Receiver, Special Tool 8526-1, into the cup of the Ball Joint Press, Special Tool C-4212F, and tighten the set screw. Install the Driver,
Special Tool 8526-2, on the tip of the Ball Joint Press screw drive as shown. Position the Driver this way to seat the bushing to its correct depth.
