Grand Caravan FWD V6-3.8L VIN L (2001)
6. If hub and bearing cannot be removed from the axle by hand, use Remover, Special Tool 8458 and following procedure to press the hub and
bearing out of the axle.
a. Thread Threaded Guide Pins into hub and bearing mounting bolt holes.
b. Remove the two outboard spring plate bolts.
c. Using the spring plate bolts, install the Screw Mount, Special Tool 8458-2, as shown.
d. Place Push Plate, Special Tool 8458-1, on ends of Threaded Guide Pins
e. Place a dab of grease in dimple of Push Plate.
f.
Tighten the Forcing Screw, Special Tool 8458-3, up against dimple in Push Plate and press hub and bearing out of axle by continuing to
tighten screw.
g. Remove the tool.
h. Reinstall the two outboard spring plate bolts. Tighten the bolts to 102 Nm (75 ft. lbs.) torque.
7. Remove the hub/bearing from the rear axle and brake support plate.
INSTALLATION
1. Install the 4 hub and bearing to axle mounting bolts into the holes in the flange of the rear axle.
2. Install the rear brake support plate on the 4 mounting bolts installed in the flange of the rear axle.
3. Align the rear hub and bearing with the 4 mounting bolts and start mounting bolts into hub and bearing. Tighten the 4 bolts in a crisscross pattern
until the hub and bearing and brake support plate is fully and squarely seated onto flange of rear axle. Tighten the 4 mounting bolts to a torque of
129 Nm (95 ft. lbs.)
NOTE: If equipped with antilock brakes, make sure wheel speed sensor stays clean and dry as it is installed into the hub and bearing cap.
4. If the vehicle is equipped with antilock brakes, perform the following:
a. If metal sensor retaining clip is not in the neutral installed position on hub and bearing cap, install from the bottom, if necessary, and push clip
upward until it snaps into position.
b. Install wheel speed sensor head into rear of hub and bearing aligning index tab with the notch in the top of the mounting hole. Push the sensor
in until it snaps into place on the metal retaining clip.
c. Install secondary (yellow) retaining clip over wheel speed sensor head and engage the tabs on each side.
5. Install brake drum or disc brake rotor and brake caliper.
6. Install wheel and tire. Tighten the wheel nuts in the proper sequence to a torque of 135 Nm (100 ft. lbs.).
7. Adjust the rear brakes as necessary.
8. Lower vehicle.
9. Road test vehicle to ensure proper operation of brakes.
