Grand Caravan FWD V6-3.8L VIN L (2001)
Transmission Control Module: Service and Repair
Pinion Factor Setting
PINION FACTOR SETTING
NOTE: This procedure must be performed if the Transmission Control Module (TCM) has been replaced with a NEW or replacement unit. Failure
to perform this procedure will result in an inoperative or improperly calibrated speedometer.
The vehicle speed readings for the speedometer are taken from the output speed sensor. The TCM must be calibrated to the different combinations of
equipment (final drive and tires) available. Pinion Factor allows the technician to set the Transmission Control Module initial setting so that the
speedometer readings Will be correct. To properly read and/or reset the Pinion Factor; it is necessary to use a DRB scan tool.
1. Plug the DRB scan tool into the diagnostic connector located under the instrument panel.
2. Select the Transmission menu.
3. Select the Miscellaneous menu.
4. Select Pinion Factor. Then follow the instructions on the DRB scan tool screen.
