Grand Caravan FWD V6-3.8L VIN L (2001)
8. Remove the four hub and bearing mounting bolts from the rear of steering knuckle. Use care not to come in contact with and damage the ABS tone
wheel on the driveshaft stub shaft upon bolt removal.
9. Remove the hub and bearing assembly from the steering knuckle.
INSTALLATION
CAUTION: Hub and bearing assembly mounting surfaces on the steering knuckle and stub axle must be smooth and completely free 0f foreign
material or nicks prior to installing hub and bearing assembly.
CAUTION: When installing hub and bearing into steering knuckle, be careful not to damage the bearing seal on the outer ON joint.
1. Install hub and bearing onto stub axle and into steering knuckle until squarely seated on the face of the steering knuckle.
2. Install the 4 hub and bearing mounting bolts from the rear of the knuckle. Equally tighten all 4 mounting bolts in a cries-cross pattern until
hub/bearing assembly is squarely seated against front of steering knuckle. Tighten mounting bolts to a torque of 65 Nm (45 ft. lbs.)