Intrepid V6-2.7L VIN R (2003)
Towing Information: Technician Safety Information
STANDARD PROCEDURE - TOWING RECOMMENDATIONS
CAUTION: Many vehicles are equipped with air dams, spoilers, and/or ground effect panels. To avoid component damage, a wheel-lift towing
vehicle or a flat-bed hauling vehicle is recommended.
Fig. 9 Tow Vehicles With Approved Equipment
A vehicle equipped with SAE approved sling-type towing equipment, a wheel-lift towing device or a vehicle with a flat-bed device can be used to
transport all RAM VAN or WAGON vehicles (Fig. 9).
A wooden crossbeam may be required for proper connection when using the sling-type, front-end towing method.
Safety Precautions
NOTE: The following safety precautions must be observed when towing a vehicle.
-
Secure loose and protruding parts.
-
Always use a safety chain system that is independent of the lifting and towing equipment.
-
Do not allow towing equipment to contact the disabled vehicle's fuel tank.
-
Do not allow anyone under the disabled vehicle while it is lifted by the towing device.
-
Do not allow passengers to ride in a vehicle being towed.
-
Always observe state and local laws regarding towing regulations.
-
Do not tow a vehicle in a manner that could jeopardize the safety of the operator, pedestrians or other motorists.
-
Do not attach tow chains, T-hooks, J-hooks, or a tow sling to a bumper, steering linkage, drive shafts or a non-reinforced frame hole.
-
Remove exhaust pipe tips that interfere with the tow sling and crossbar
-
Padding should be placed between the tow sling/crossbar and any painted surfaces
-
When placing tow hooks on the rear axle, position them so they do not damage the brake tubing or hoses
-
Do not tow the vehicle by connecting to the front or rear shock absorbers
-
Do not tow a heavily loaded vehicle. Damage to the vehicle may result. Use a flatbed device to transport a loaded vehicle.
Ground Clearance
CAUTION: If vehicle is towed with wheels removed, install lug nuts to retain brake drums.
A towed vehicle should be raised until lifted wheels are a minimum 100 mm (4 in) from the ground. Be sure there is adequate ground clearance at the
opposite end of the vehicle, especially when towing over rough terrain, steep rises in the road or if the vehicle is equipped with air dams, spoilers,
and/or ground effect panels. If necessary, remove the wheels from the lifted end of the vehicle and lower the vehicle closer to the ground, to increase
the ground clearance at the opposite end of the vehicle. Install lug nuts on wheel attaching studs to retain brake drums.
Ramp Angle
If a vehicle with flat-bed towing equipment is used, the approach ramp angle should not exceed 15 degrees.
