Intrepid V6-2.7L VIN R (2003)
Road Temperature Sensor: Testing and Inspection
Ambient Temperature Sensor Circuit Test
1. Turn the ignition switch to the OFF position. Disconnect and isolate the battery negative cable. Disconnect the 2-way ambient temperature sensor
wire harness connector and the 22-way Body Control Module (BCM) wire harness connector.
2. Connect a jumper wire between the two terminals in the body half of the 2-way ambient temperature sensor wire harness connector.
3. Check for continuity between the sensor return circuit and the ambient temperature sensor signal circuit cavities of the 22-way BCM wire harness
connector. There should be continuity. If OK, go to Step 4. If not OK, repair the open sensor return circuit or ambient temperature sensor signal
circuit to the ambient temperature sensor as required.
4. Remove the jumper wire from the body half of the 2-way ambient temperature sensor wire harness connector. Check for continuity between the
sensor return circuit cavity of the 22-way BCM wire harness connector and a good ground. There should be no continuity. If OK, go to Step 5. If
not OK, repair the shorted sensor return circuit as required.
5. Check for continuity between the ambient temperature sensor signal circuit cavity of the 22-way BCM wire harness connector and a good ground.
There should be no continuity. If OK, refer to Diagnosis and Testing - Electronic Vehicle Information Center in this group. If not OK, repair the
shorted ambient temperature sensor signal circuit as required.
