Intrepid V6-2.7L VIN R (2003)
Body Control Module: Service and Repair
REMOVAL
1. Remove the Junction Block/BCM from the vehicle.
2. Remove the four BCM attaching screws from the Junction Block.
3. Disconnect BCM from the Junction Block.
NOTE:
-
The Remote Keyless Entry (RKE) module is attached to the BCM with three screws. This must be transferred (if equipped) to the new BCM.
-
If the BCM is replaced, the Vehicle Theft / Security System (VTSS (if equipped) must be enabled in the new BCM via the DRB III scan tool in
order to start the vehicle.
INSTALLATION
1. Connect the BCM to the Junction Block.
2. Install the four BCM attaching screws to the Junction Block.
3. Install the Junction Block/BCM into the vehicle.
