Intrepid V6-2.7L VIN R (2003)
Fig.14 Inner Front Door Trim Panel - Typical
11. Disconnect the linkage from the remote handle assembly.
12. Disconnect the power mirror switch.
13. Disconnect the power door lock switch wire connector.
14. Disconnect the power window switch wire connector.
15. Disconnect the radio speaker wire connector.
16. Disconnect wiring harness clips from trim panel.
17. Disconnect the courtesy lamp, if equipped.
18. Remove trim panel from vehicle.
INSTALLATION
1. Place door trim panel in position.
2. Install wire harness clips into door trim panel.
3. Connect the courtesy lamp, if equipped.
4. Connect the radio speaker wire connector.
5. Connect the power window switch wire connector.
6. Connect the power door lock switch wire connector.
7. Connect the power mirror switch wire connector.
8. Connect the linkage to the handle assembly.
9. Hook door trim panel over the sheet metal flange.
10. Insert the forward four way alignment guide into position. Insert the rearward two way alignment guide into position.
11. Engage rear retaining clips to attach door trim panel to inner sheet metal panel, up to three ratchet clicks.
12. Install three screws in the speaker area.
13. Install two screws in the instrument panel interface area.
14. Install screw in the remote bezel, and close trim plug.
15. Install screw in pull cup, and close trim plug.
16. Install three screws to the bottom of the door. Tighten all screws to 1.3 to 1.9 N.m (12 to 17 in.lbs.) torque.
17. Place speaker grille in position on trim panel.
