Intrepid V6-2.7L VIN R (2003)
5. Remove nut and screw securing transmission control module to vehicle.
6. Lift the transmission control module (with speed control servo attached) from its mount leaving its wiring harness attached. Move it off to the side
toward the engine making sure not to strain the wires and speed control servo cable.
7. Clean any debris away from the fittings on top of the junction block.
8. Remove the two brake tubes coming from the primary and secondary master cylinder ports at the junction block.
9. Remove the four chassis brake tubes going to each brake, mounted across the front top of the junction block.
10. There are two bolts fastening the junction block and mounting bracket to the engine cradle crossmember. Remove the outboard bolt fastening the
mounting bracket to the engine cradle crossmember.
11. Raise the vehicle. See hoisting in Lubrication and Maintenance.
12. Loosen, but do not remove, the remaining mounting bolt fastening the junction block mounting bracket to the engine cradle crossmember.
13. Pivot the junction block and bracket forward on the remaining mounting bolt and remove the junction block and bracket from the vehicle.
INSTALLATION
