Intrepid V6-2.7L VIN R (2003)
Wheel Speed Sensor: Service and Repair
Front
FRONT WHEEL SPEED SENSOR
REMOVAL
1. Raise vehicle.
2. Remove the tire and wheel assembly from the vehicle.
3. Remove bolt securing the speed sensor cable routing bracket to the strut assembly.
4. Remove retainer, holding the speed sensor sealing grommet, from the inner fender. pull the grommet out, then unplug the speed sensor cable from
the vehicle wiring harness
5. Remove bolt attaching speed sensor to steering knuckle. Carefully remove speed sensor head from steering knuckle. If sensor is seized in place by
corrosion, tap the edge of the sensor ear with a hammer and brass punch, working it side to side.
CAUTION: If speed sensor head locating pin has seized to the steering knuckle, do not attempt to remove speed sensor head by grasping with
pliers and turning. This will damage the speed sensor head. Use only the following procedure.
INSTALLATION