Intrepid V6-2.7L VIN R (2003)
7.
Remove the fuel control valve from the fuel tank and determine the mold cavity number, refer to (Fig. 2). If the mold cavity number is 4, replace
the control valve with p/n 05016387M.
NOTE:
IF THE VALVE WAS STUCK CLOSED, THE SYSTEM WOULD BE UNABLE TO VENT CAUSING A SLOW FILL CONDITION. IF THE
VALVE WAS STUCK OPEN, THE VEHICLE COULD BE "OVERFILLED" CAUSING LIQUID FUEL CARRY OVER INTO THE CANISTER.
8.
Some vehicles may have a fuel filler tube recirculation line that is plugged or restricted with paint from the filler tube supplier's manufacturing
process. Remove the fuel filler tube.
9.
To check for this condition insert a small ball bearing (1/4 in.) at the fuel tank end of the fuel filler tube recirculation line. If the line isn't blocked
the ball bearing will travel freely through the recirculation line and out into the larger tube. If plugged or restricted, replace the fuel filler tube
assembly, p/n 0458319AB.
10.
Install the fuel tank and replace the fuel that was drained.
11.
Connect the battery and set the clock to the correct time.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
