dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Engine Controls - False MIL ON/False DTC's Set|Page 4412 > < Engine/Transmission Controls - MIL ON/False DTC's|Page 4407
Page 1
background image

PROM - Programmable Read Only Memory: All Technical Service Bulletins
Engine Controls - False MIL ON/False DTC's Set

NUMBER: 18-032-02

GROUP: Vehicle Performance

DATE: Oct. 21, 2002

THIS BULLETIN IS BEING PROVIDED IN ADVANCE. THE MDS2 MUST BE OPERATING WITH CIS CD2120 OR HIGHER, AVAILABLE
NOVEMBER 11, 2002.

SUBJECT:
Flash: Erroneous MIL Illumination - Erroneous Diagnostic Trouble Codes (DTC's)

OVERVIEW:
This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with revised software.

MODELS:
2003 (LH) 300M/Concorde/Intrepid

NOTE: 

THIS INFORMATION APPLIES TO VEHICLES EQUIPPED WITH A NEXT GENERATION CONTROLLER (NGC) POWERTRAIN
CONTROL MODULE (PCM) BUILT PRIOR TO OCTOBER 15, 2002 (MDH1015XX).

SYMPTOM/CONDITION:

The Malfunction Indicator Lamp (MIL) may illuminate due to erroneous detection DTCs. DTCs that may or may not be present are shown.

DIAGNOSIS:

Using a Scan Tool (DRB III(R)) with the appropriate Diagnostic Procedures Manual, verify all engine systems are functioning as designed. If DTCs are
present, other than those listed above, record them on the repair order and repair as necessary before proceeding further with this bulletin. If the
Symptom/Condition is present, perform the Repair Procedure.

PARTS REQUIRED

EQUIPMENT REQUIRED

REPAIR PROCEDURE:

Engine Controls - False MIL ON/False DTC's Set|Page 4412 > < Engine/Transmission Controls - MIL ON/False DTC's|Page 4407