Intrepid V6-2.7L VIN R (2003)
the menu screen:
a.
Select # 1 - "DRB III Standalone" from Main Menu screen.
b.
Select # 1 - "1998 - 2004 Diagnostics" from Standalone Main Menu screen.
c.
Select # 1 - "All (Except Below)" from 1998 - 2004 Diagnostics screen.
d.
Select # 8 - "System Monitor" from Select System screen.
e.
Select # 3 - "J1850 Module Scan" from Select Monitor screen and then press ENTER to continue and note if the vehicle is equipped with
SKIM.
>
If the vehicle is equipped with SKIM obtain the vehicle PIN
(Personal Identification Number) before continuing with Step 3.
This information is available from the original selling invoice, the
Dial VIP System, or by contacting the DaimlerChrysler Customer
Assistance Center (DCCAC) at 1-800-992-1997.
WARNING:
Failure to use the SKIM PIN number to transfer the secret key code data from the SKIM module will cause a no-start condition.
>
If the vehicle is not equipped with SKIM then continue with Step 3.
f.
Press PAGE BACK.
3.
Press PAGE BACK to return to the Select System screen.
4.
Select # 1 - "Engine" from Select System screen.
5
Press ENTER to continue.
6.
Press the RIGHT ARROW key to go to Page 2 of 2.
7.
Select # 1 - "Miscellaneous".
8
Select # 3 - "Check VIN".
9.
Press ENTER to program the VIN.
If the vehicle is equipped with SKIM:
a.
Press ENTER to continue.
b.
Press ENTER to continue again.
c.
Enter the vehicle 4-digit PIN.
d.
Press ENTER to continue.
e.
Press ENTER to continue again.
f.
Press ENTER to continue again.
g.
Press ENTER to update VIN.
h.
Press ENTER to continue.
i.
Press ENTER to transfer secret key data.
j.
Press ENTER to continue.
k.
Cycle ignition key to "OFF" position and then back to "ON" position and then press ENTER.
l.
Press any key to continue.
