Intrepid V6-2.7L VIN R (2003)
NOTE:
**Using the DRBIII(R) preform the proper Quick Learn procedure. Refer to the service information available in TechCONNECT or the appropriate
service manual in Section 8E - Electronic Control Modules.**
NOTE:
Due to the PCM reprogramming procedure, a DTC may be set in other modules (TCM, BCM, MIC, SKIM, etc.) within the vehicle, if so equipped.
Some DTC's may cause the MIL to illuminate. All DTC's relate to a loss of communications with the module that is being reprogrammed. Check all
modules, record the DTC's, and erase these DTC's prior to returning the vehicle to the customer. Erase any DTC's in the PCM only after all other
modules have had their DTC's erased.
NOTE:
The following steps are required by law.
4.
Type the necessary information on the "Authorized Software Update Label" p/n 04669020 (Fig. 1). Attach the label to the controller and cover the
label with the clear plastic overlay.
5.
Type the necessary information on the "Authorized Modification Label" p/n 04275086AB and attach near the VECI label (Fig. 2).
POLICY:
Reimbursable within the provisions of the warranty.
