Intrepid V6-2.7L VIN R (2003)
Seat Heater Switch: Service and Repair
Passenger Heated Seat Switch Replacement
REMOVAL
1. Disconnect and isolate the negative battery cable remote terminal from the remote battery post.
Fig.6 Heated, Memory And Power Seat Switch Locations
2. Remove the appropriate seat cushion side shield. Refer to the Body section of this manual for the procedure.
3. Working from the underside of the switch, gently rock the switch back and forth out of its mounting location.
4. Disconnect the heated seat switch electrical connector and remove the switch.
INSTALLATION
1. Connect the heated seat switch electrical connector
2. Push the heated seat switch into its mounting location.
3. Install the appropriate seat cushion side shield. Refer to the Body section of this manual for the procedure.
4. Connect the remote negative battery cable.
