Intrepid V6-2.7L VIN R (2003)
Tire Pressure Sensor: Testing and Inspection
DIAGNOSIS AND TESTING - TIRE PRESSURE SENSOR
NOTE: Tire pressure may increase from 2 to 6 psi (14 to 41 kPa) during normal driving conditions. DO NOT reduce this normal pressure build up.
If a fault in the system is detected, always check air pressure in the tires first with a known accurate air gauge and correct the inflation pressure as
necessary. If any tire is low, inspect all tires.
NOTE: If a tire and wheel rotation is not followed by the retrain procedure, the system will not properly inform the driver with the correct vehicle
location for a low or high pressure tire.
If gauge-read pressure in the tires does not reflect the data on the EVIC, retrain the sensors, then reevaluate. If the gauge-read readings at each tire still
do not reflect the EVIC data, check the accuracy of the air gauge (What is the accuracy tolerance of the gauge being used?). If the gauge used is
known to be accurate and one or more gauge readings still do not reflect the EVIC readings, but the remaining gauge readings do, replace the pressure
sensor(s) at the suspect wheels.
Refer to the appropriate diagnostic information for complete diagnosis of the Tire Pressure Monitoring System.
