Intrepid V6-2.7L VIN R (2003)
6. Install lower ball joint stud into steering knuckle. Install steering knuckle to lower ball joint stud, clamp bolt and nut into steering knuckle. Tighten
the clamping bolt to a torque of 55 Nm (40 ft. lbs.).
7. Install the wheel and tire assembly.
8. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification. Then repeat the tightening sequence to the
full specified torque of 129 Nm (95 ft. lbs.).
9. Lower vehicle so the suspension is supporting vehicles weight (control arm at design height). Tighten the lower control arm pivot bushing to
cradle bracket attaching bolt to a torque of 142 Nm (105 ft. lbs.).