Intrepid V6-2.7L VIN R (2003)
9. Unseat cable grommet at firewall and remove cable from interior of vehicle (Fig. 255).
10. Raise vehicle on hoist and disconnect fill tube bracket from transaxle. Rotate fill tube to gain access to shift cable clamp.
11. Remove cable from routing bracket (Fig. 256)
12. Remove cable-to-transaxle nut and slide cable off of stud (Fig. 255).
13. Disconnect shifter cable from shift lever assembly at transaxle (Fig. 255).
14. Remove cable from underneath vehicle.
INSTALLATION
1. Make sure transaxle shift lever is in "Park." This is the most rearward position. Verify park sprag is fully engaged by rotating either a tire or an
axle shaft.
2. Position cable in vehicle and connect cable end to the transaxle shift lever (Fig. 255).
3. Verify that the washer (Fig. 255) is still in place on the cable mounting stud. Install cable to transaxle and tighten nut to 28 Nm (250 inch lbs.).
4. Rotate fill tube to original location. Install and tighten fill tube bracket bolt.
5. Install cable "push pin" into bracket as shown in (Fig. 254).
