Intrepid V6-2.7L VIN R (2003)
6. Route transaxle shift cable through hole in dash panel (Fig. 255) (Fig. 257).
7. Lubricate cable grommet with a synthetic lubricant (or equivalent) and secure to hole. Verify that it is seated by gently pulling outward on cable.
8. Install cable into throttle/gearshift cable bracket (Fig. 254).
9. Inside the vehicle, route the gearshift cable between the left a/c duct and the left lower heat duct (Fig. 257) and towards the gearshift mechanism.
10. Route cable through hole in shifter conduit bracket and attach to cable attaching shift pin by snapping into place (Fig. 253).
11. Install a new clip onto the cable at the shifter bracket (Fig. 253).
12. Tighten the adjuster nut (Fig. 252)
13. Reinstall console bezel and shifter handle. Firmly press the shifter handle downward and tighten the screw (Fig. 251).
14. Check shifter for proper operation. It should operate smoothly without binding. The starter should crank in Park or Neutral only.
