Intrepid V6-2.7L VIN R (2003)
7. Install the strut assembly to steering knuckle attaching bolts. Install nuts on attaching bolts (Fig. 15). Tighten the strut assembly to steering knuckle
bolt nuts to 210 Nm (155 ft. lbs.). TURN NUTS ON BOLTS. DO NOT TURN BOLTS.
CAUTION: The hub and bearing assembly to stub shaft retaining nut is a prevailing torque nut and can not be reused. A NEW retaining nut MUST be
used when assembled.
8. Install a NEW retaining nut (Fig. 16). Tighten, but do not torque the hub nut at this time.
9. Install speed sensor cable routing bracket on front strut assembly. Install and securely tighten routing bracket screw.
