Intrepid V6-2.7L VIN R (2003)
8. Carefully pull the pump out of the reservoir.
NOTE: When replacing the pump, make sure to use a new grommet for proper sealing and to avoid leaks.
INSTALLATION
NOTE: When replacing the pump, make sure to use a new grommet for proper sealing and to avoid leaks.
1. Install the new pump grommet.
2. Position pump motor over grommet and firmly snap into place.
3. Place reservoir into position in engine compartment, pivot the inboard side of the reservoir rearward.
4. Connect the washer filler hose.
5. Connect the washer hose.
6. Connect the pump and sensor wire connectors.
7. Install the four retaining bolts to the washer reservoir.
8. Install the left headlamp assembly. Refer to Electrical, Lamps/Lighting - Exterior Headlamp Unit (Intrepid), INSTALLATION.
9. Connect the negative battery cable remote terminal to the remote battery post.
