Intrepid V6-2.7L VIN R (2003)
Windshield Washer Reservoir: Service and Repair
Washer Reservoir Filler Tube Replacement
REMOVAL
1. Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
2. Hoist vehicle.
3. Remove front fascia as necessary (left side only and use a 2x4 to prop left edge of fascia away from body). Refer to Body for REMOVAL.
4. Reach up behind the washer reservoir and pull the filler tube off the rear of the reservoir.
Washer Reservoir Filler Tube
5. Remove one screw attaching washer reservoir filler tube to upper radiator support
6. Pull filler tube and hose up through left fender and remove.
INSTALLATION
1. Place filler tube in engine compartment and route through left fender.
2. Install the one screw attaching washer reservoir filler tube to upper radiator support
3. Reach up behind the washer reservoir and install the filler tube on the rear of the reservoir.
4. Install the front fascia as necessary (left side only and use a 2x4 to prop left edge of fascia away from body). Refer to Body for INSTALLATION.
5. Lower vehicle off hoist.
6. Connect the negative battery cable remote terminal to the remote battery post.
