Intrepid V6-2.7L VIN U (2000)
4. Follow the manufacturers recommended procedure and evacuate the fluid from the transaxle.
5. Remove the suction line from the dipstick tube.
6. Pour four quarts of Mopar(R) ATF +4 (Automatic Transmission Fluid) Type 9602 through the dipstick opening.
7. Start engine and allow to idle for at least one minute. Then, with parking and service brakes applied, move selector lever momentarily to each
position, ending in the park or neutral position.
8. Check the transaxle fluid level and add an appropriate amount to bring the transaxle fluid level to 3mm (1/8 inch) below the "ADD" mark on the
dipstick.
9. Recheck the fluid level after the transaxle has reached normal operating temperature (180°F.).
10. To prevent dirt from entering transaxle, make certain that dipstick is fully seated into the dipstick opening.
