Intrepid V6-201 3.3L (1995)
Door Latch Handle Rod
12. Disengage clip holding linkage rod to inside latch handle and separate rod from handle.
Front Door Panel Hooks And Lock Bottom
13. Lift trim panel upward to disengage hook retainers at bottom of trim panel and separate trim panel from door.
14. Disengage wire connector from power door lock motor located on door latch.
15. From behind door silencer pad, disengage push-in retainers holding wire harness to trim panel.
16. Remove wire harness from behind silencer pad and separate trim panel from door.
INSTALLATION
1. Install wire harness behind silencer pad and place trim panel from door.
2. Behind door silencer pad, engage push-in retainers to hold wire harness to trim panel.
3. Engage wire connector to power door lock motor.
4. Place trim panel in position on door and engage hook retainers at bottom of trim panel into holes in door.
5. Insert latch rod into clip on latch handle. Engage clip to hold rod to handle.
6. Engage wire connector to speaker, if equipped.
7. Engage wire connector to power door lock switch, if equipped.
8. Engage trim panel into channel retainer at top door.
9. If wire harness was removed with door trim panel, route harness under weatherstrip. Engage door jamb connector. Install fasteners to hold wire
harness close-out cover to door end frame. Engage push-in retainers to hold door opening weatherstrip to door end frame.
10. Install screw to hold trim panel to door behind inside latch handle.
11. Place pull cup in position into arm rest on trim panel.
12. Install screw to hold pull cup to trim panel.
13. Install screws to hold trim panel to door inside speaker opening.
14. Place speaker grille in position on trim panel. Engage clips to hold door speaker grille to trim panel.
15. Install window crank, if equipped.
