Intrepid V6-201 3.3L (1995)
Air Door Actuator / Motor: Description and Operation
Blend Door Actuator
Description
DESCRIPTION
The blend-air (temperature) door actuator is an electric motor which mechanically positions the temperature door.
OPERATION
A feedback strip in the actuator allows the computer control to know the exact position of the temperature door at all times.
NOTE: The blend-air door actuator is not serviceable and must be replaced if found to be defective.
Circuit Operation
CIRCUIT OPERATION
The blend air door actuator is located on the bottom of the A/C-Heater housing at the center tunnel.
Power for the mode door actuator is supplied on circuit C26 from the Body Control Module (BCM). This is a 5 Volt feed.
Circuit C33 is the blend air drive circuit from the BCM to the actuator.
The C36 circuit is the feedback from the actuator to the BCM. The BCM uses this information to adjust the door to the proper position.
Circuit C57 is the sensor return to the BCM. This circuit is spliced with the other actuators in the housing.
Circuit C34 is the common line that is spliced, and connects, to the other sensors in the housing.
