Intrepid V6-201 3.3L (1995)
16.
Remove steering column covers from steering column
17.
Remove steering column retaining bolts and allow steering column to lower to floor.
18.
Remove wiring from steering column.
19.
Remove center instrument panel retaining bolt at center console bracket.
20.
Remove right side floor air duct.
21.
Disconnect 10-way connector, blower module connector, blower motor connector, and Airbag Control Module (ACM) connector at center wiring.
22.
Remove Body Control Module (BCM) attaching bolt from instrument panel, and let hang to floor.
23.
Disconnect right side wiring connector and antenna connector.
24.
Remove right and left side upper instrument panel mounting screws located in door jamb. Proceed to step 28 for 1994 and 1995 model year
vehicles.
STEPS 25 THRU 27 APPLY TO 1993 M.Y. ONLY
25.
Remove the instrument panel assembly from the vehicle and stuff the upper defroster ducts with shop towels.
26.
Modify instrument panel defrost duct by cutting a rectangular slot, 14 mm by 40 mm, in each duct as shown in the drawing (rectangular slots must
line up with holes in plenum pad).
27.
If foam strips are not in place at top of defrost duct, install four foam strips, P/N 4746277 (TSB 24-03-93 Rev. A).
28.
Install revised plenum pad, P/N 4814040.
29.
Reverse above procedure to reassemble instrument panel. Install revised top cover assembly, P/N 4758823 (W ATC) or P/N 4758824 (W/O
ATC).
30.
Connect negative battery cable and reset previously recorded radio stations and clock.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
24-65-50-90 Replace Instrument Panel Top Cover, Plenum
Pad, And Modify Ducts (1993 Only)
1993 M.Y
2.2 Hrs
1994/1995 MY
7 Hrs.
Optional Equipment,
Console Equipped
24-65-50-60
0.2 Hrs.
