dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Heater-A/C Housing Removal and Installation|Page 7310 > < Heater-A/C Housing Removal and Installation
Page 2
background image

Center Bezel Removal

13. Remove the center instrument panel bezel. This bezel is held in place by four clips. It can be removed by carefully prying it from the instrument

panel.

14. Remove center console from vehicle (if equipped).
15. If the vehicle is equipped with a right side air bag, the glove box must be lowered. The glove box assembly can be lowered by pressing in on the

sides of the glove box. This will release the glove box and allow access to air bag mounting screws. There are four screws located behind the glove
box. Remove these screws and then close the glove box.

16. Remove lower bolster retaining screws.
17. Carefully lower the bolster and disconnect the trunk release and glove box light wiring. Then remove the lower bolster from the vehicle.

Panel Top Cover

18. Remove the instrument panel top cover. It is held in place by retainer clips at both ends of the cover. To remove carefully pry upward at one end of

the cover until the clip is disengaged. Proceed to the opposite side and gradually pry the rear edge of the top cover along the entire width of the
panel.

19. Remove right and left windshield pillar trim covers.
20. Remove five bolts that hold instrument panel to the cowl. These bolts are located at the base of the windshield.
21. Disconnect the scan tool (DRB) connector from brace.
22. Remove instrument panel ground strap. This strap is located on the lower left side of the center console.
23. Remove left knee blocker support bracket. This will allow access to the 60 way wiring connector.
24. Remove under column duct and left floor duct.
25. Disconnect 60 way wiring connector. Then disconnect all related wiring connectors.
26. Disconnect fuse panel wiring connectors.
27. Disconnect the brake light switch connector.
28. Remove steering column covers from steering column.
29. Remove steering column retaining bolts and allow the steering column to lower to the floor. Do not completely remove the column from the

vehicle.

30. Remove wiring from the steering column.
31. Remove air bag connectors.

Heater-A/C Housing Removal and Installation|Page 7310 > < Heater-A/C Housing Removal and Installation