Intrepid V6-201 3.3L (1995)
32. Remove right side floor air duct.
33. Disconnect 10 way connector, blower module connector and blower motor connector.
34. Remove body controller from vehicle.
35. Disconnect right side connector and antenna connector.
36. Remove right and left side upper instrument panel mounting screws located in door jam.
37. Remove upper instrument panel from the vehicle. The upper instrument panel will be removed with all harnesses and gauges still in the panel. It is
recommended that two people handle the upper panel while removing.
38. Remove air duct for rear heater vents. It is held in place by a bracket/push pin near the rear of the duct.
39. Remove the air bag module and brace from the vehicle.
40. Remove three attaching bolts which holds the heater housing to the dash panel.
41. Carefully roll the heater housing out of the vehicle.
42. After removing the heater housing, remove the drain tube from the heater housing. The drain tube should be installed from underneath the vehicle
after the heater housing is reinstalled into the vehicle.
INSTALLATION
For installation, reverse the above procedures.
