Intrepid V6-201 3.3L (1995)
5. Remove hub bolts, then remove hub and bearing assembly from steering knuckle by sliding it straight off end of stub axle. If metal seal on hub and
bearing assembly is seized to steering knuckle and becomes dislodged on hub and bearing assembly during removal, or when removing hub and
bearing, the flinger disc on hub becomes damaged, hub and bearing assembly must be replaced.
Fig. 3 Hub & Bearing Removal
6. If hub and bearing will not slide out of knuckle, insert a pry bar between hub and steering knuckle and gently pry hub and bearing from knuckle.
7. Reverse procedure to install, noting the following:
a. Always use a new stub shaft nut when installing.
b. Tighten stub shaft nut, then lower vehicle and, with brakes applied, torque stub shaft nut to 120 ft-lbs.
