Intrepid V6-201 3.3L (1995)
6.
Spread ears on race retaining ring with snap ring pliers and remove C/V joint assembly from axle shaft and discard.
7.
Remove old sealing boot from axle shaft and discard.
8.
Slide new small boot clamp along axle shaft. Do not crimp.
9.
Slide new sealing boot along axle shaft. Do not crimp.
10.
Place approximately half of the grease provided inside the new C/V joint.
11.
Push new C/V joint onto axle shaft until the retaining ring is fully seated in the groove on the axle shaft.
12.
Place the remaining grease inside the new sealing boot and position the small end of boot in groove on the shaft as indicated. Crimp small boot
clamp using Crimper, Special Tool C-4975-A.
13.
Slide large diameter of sealing boot with large seal retaining clamp in place over outside of C/V joint race and locate seal lip in groove.
14.
Clamp large sealing boot retaining clamp using Crimper, Special Tool C-4975-A.
15.
Install axle shafts in vehicle as described on Pages 2-43 thru 2-46 of the 1995 Concorde/Intrepid/Vision/LHS/New Yorker Service Manual
(Publication No. 81-270-5121). TORQUE FRONT HUB NUTS TO 120 +/- 10 FT. LBS.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No. 02-16-05-90
Both Sides ...................................................................................................................................................... 1.2 Hrs.
