Intrepid V6-201 3.3L Flex Fuel (1994)
Fig. 5 Timing Chain Case Cover Gaskets and O-Rings
2. Use a new cover gasket and 0-rings. (Fig. 5).
3. Rotate crankshaft so that the oil pump drive flats are vertical.
4. Position oil pump inner rotor so the mating flats are in the same position as the crankshaft drive flats (Fig. 5).
5. Install cover onto crankshaft. Make sure the oil pump is engaged on the crankshaft correctly or severe damage may result.
6. Install chain case cover screws (Fig. 2). Snug the two bottom screws and the top center screwy. Ensure the cover is seated to the block then torque
all other screws to 27 Nm (20 ft.lbs.).
Fig. 6 Install Crankshaft Oil Seal
7. Install crankshaft oil seal (Fig. 6).
