Intrepid V6-201 3.3L Flex Fuel (1994)
8.
Remove the transfer chain snubber and screws and replace them with the parts listed in the Transfer Chain Snubber Kit. Tighten the snubber
screws to 5 N-m (40 in.lbs.).
NOTE:
DISREGARD THE SNUBBER GAP MEASUREMENT PROCEDURE. IT IS NOT REQUIRED WITH THE NEW RUBBER FACED
SNUBBER.
9.
Install the transmission rear cover. Tighten the attaching screws to 29 N-m (250 in.lbs.).
10.
Install the removed components in reverse order.
11.
Fill and adjust the transmission fluid level following the proper procedures.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
21-10-14-90
2.1 Hrs.
FAILURE CODE: P8 - New Part