Intrepid V6-215 3.5L (1995)
NOTE:
DO NOT RE-USE ANY OF THE SEALS ORIGINALLY INSTALLED IN THE TRANSAXLE.
1.
Using the procedures outlined in the appropriate Service Manual, remove the transaxle from the vehicle and install the appropriate parts specified
in the Parts Required section of this bulletin.
2.
Inspect the 2-4 accumulator piston. If it is made of plastic, replace it with an aluminum piston (P/N 4446620) and 2 teflon seal rings (P/N
4446544).
3.
When installing the replacement 2-4 clutch plates and discs, the plate orientation should be alternated so the pilot pads of adjacent plates do not
align, refer to the illustration.
4.
During the re-assembly, be sure to check and adjust as necessary all clutch clearances. For this repair, the preferred Low/Reverse clutch clearance
is between 0.89 mm (.035 in.) and 1.04 mm (.042 in.).
5.
The seals used for the low/reverse clutch piston and 2/4 clutch piston have been revised to D-ring type seals. Under NO circumstances, use a lip
type seal for these applications.
6.
If friction material was found in the transaxle oil pan or the oil pump assembly, reverse flush and flow check the oil cooler and tubes using Miller
