Intrepid V6-215 3.5L (1995)
Body Controller: Service and Repair
RKE Transmitter Programming
1. Turn the ignition on (transmission in park position).
2. Ground the RKE module program enable wire (DG). This wire is located: 1993-1995 in the traction control connector. For 1996-1997 use the
DRBIII and select "Program RKE" under "Miscellaneous". (The receiver will cycle the door locks to inform it is in programming mode.)
3. Press any single button on the transmitter. The locks will cycle as feedback.
4. Program the second transmitter at this time. NOTE: All transmitters that are going to be used with this vehicle must be programmed at the same
time.
5. Remove the ground wire.
6. If further information is needed, perform TEST 102A.
