Intrepid V6-215 3.5L (1995)
Technical Service Bulletin #
08-13-99
Date:
990507
Oxygen Sensor - MIL ON With Hex Code $3E or $42
Number: 08-13-99
Group: Electrical
Date: May 7, 1999
SUBJECT:
MIL Illumination With Hex Code $3E Or $42, Possible Sags/Hesitations Or Rough Idle
OVERVIEW:
This bulletin involves cutting and splicing a wiring jumper from the right and left oxygen sensors to the Powertrain Control Module (PCM).
MODELS:
1995 - 1996 (LH) Concorde/Intrepid/Vision/LHS/New Yorker
SYMPTOM/CONDITION:
MIL illumination with hex code $3E - LEFT UPSTREAM 02 SENSOR SHORTED TO VOLTAGE Or $42 - RIGHT UPSTREAM O2 SENSOR
SHORTED TO VOLTAGE along with possible symptoms of sags/hesitation or rough idle.
NOTE:
HEX CODE $3E (P0132) OR $42 (P0152) MUST HAVE OCCURRED FOR THIS REPAIR TO BE EFFECTIVE.
DIAGNOSIS:
Using the Mopar Diagnostic System (MDS1/MDS2) or the Diagnostic Scan Tool (DRB III(R)) and the appropriate Diagnostic Procedures Manual,
verify all engine systems are functioning as designed. If Diagnostic Trouble Codes (DTC's) are present, record them on the repair order and repair as
necessary before proceeding further with this bulletin. If DTC $3E or $42 is present, follow the diagnostic procedure in the applicable diagnostic
manual. If no apparent reason is found for the DTC, perform the Repair Procedure.
PARTS REQUIRED:
AR(1)
5013596AA
Jumper, Wire (1995 3.5L)
AR(1)
5013597AA
Jumper, Wire (1995 3.3L)
AR(1)
5013598AA
Jumper, Wire (1996 3.5L)
AR(1)
5013599AA
Jumper, Wire (1996 3.3L)
AR
04778138
Tape, Cloth Electrical
AR
04778570
Tubing, Heat Shrink
AR
04641780
Strap, Tie
EQUIPMENT REQUIRED:
1
NPN
Soldering Iron
1
NPN
Rosin Core Solder
1
CH6000
Scan Tool (DRB III(R))
1
CH7035
General Purpose Interface Bus Cable (GPIB)
1
CH7000/7001
J1962 Cable
1
MDS1 or MDS2
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
08-90-65-93
3.3L Engines
0.8 Hrs.
Labor Operation No:
08-90-65-94
3.5L Engines
0.9 Hrs.
FAILURE CODE: 5W - Broken Splice In Harness
Repair Procedure
1.
Disconnect the battery negative lead.
2.
Remove the air cleaner assembly. On 3.5L models, also remove the air intake from the throttle body.
3.
Locate the right oxygen sensor connector and disconnect it.
