Intrepid V6-215 3.5L (1995)
1.
Using the procedures outlined in Section 21 of the appropriate Service Manual, remove the transaxle valve body.
2.
Remove the 2-4 accumulator retaining plate and the plastic accumulator piston.
3.
Assemble the two teflon seal rings (P/N 4446544) on to the replacement aluminum piston (P/N 4446620).
4.
Install the piston/seal ring assembly and retaining plate into the valve body.
5.
Using the procedure outlined in Section 21 of the appropriate Service Manual, install the transaxle valve body, oil pan and adjust the transaxle
fluid level.
6.
Use the Mopar Diagnostic System (MDS) or the Scan Tool (DRB III) to erase the (DTC's) in the TCM.
NOTE:
1996 NS VEHICLES MAY HAVE A DTC 45 (CHECK TRANSMISSION SYSTEM) STORED IN THE POWERTRAIN CONTROL MODULE
(PCM) AND MAY ILLUMINATE THE "CHECK ENGINE" LIGHT. ON THESE 1996 NS VEHICLES, THE DTC's IN THE TCM MUST BE
ERASED FOLLOWED BY THE DTC'S IN THE PCM TO TURN THE "CHECK ENGINE" LIGHT OFF.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
21-80-03-91
1.4 Hrs.
FAILURE CODE: P8 - New Part
