Intrepid V6-3.2L VIN J (1998)
15.
Using a sharp utility knife cut the flocking tape along the edge of the door trim panel (Figure 5). Care must be used not to cut too deep into the
metal and not cutting the vinyl on the panel.
16.
Remove the excess flocking tape.
17.
Clean grease pencil mark off door.
18.
Install C-pillar flag trim.
19.
Remove the duct tape from the outer belt molding.
20.
Verify function of remote handle and door lock.
21.
Repeat procedure on other rear door if necessary.
Technical Service Bulletin # 23-29-00
Date: 000707
Rear Door Trim Panel - Loose At Upper Rear Corners
NUMBER: 23-29-00
GROUP: Body
DATE: July 7, 2000
THIS BULLETIN SUPERSEDES TECHNICAL SERVICE BULLETIN 23-05-99, DATED February 12, 1999 WHICH SHOULD BE REMOVED
FROM YOUR FILES AND NOTED IN THE 1999 TECHNICAL SERVICE BULLETIN MANUAL (PUBLICATION NO. 81-699-00004). ALL
REVISIONS ARE HIGHLIGHTED WITH **ASTERISKS** AND INCLUDE ADDITIONAL MODELS.
SUBJECT:
Rear Door Trim Panel Loose At Upper Rear Corner
OVERVIEW:
This bulletin involves installing a screw securing the door trim panel and adding flocking tape to the interface between the rear of the door panel and
sheet metal on **some** Concorde/LHS/300M vehicles.
MODELS:
1998 - **2001**
(LH)
Concorde/Intrepid/LHS/300M
SYMPTOM/CONDITION:
Rear door trim panel may be loose (pulled away from inner sheet metal) at the top rear corner. Condition may be aggravated by slamming the door shut.
DIAGNOSIS:
If door trim panel is installed properly (all fasteners secure) but can be pulled loose at the upper rear corner or loosens when the door is slammed,
perform the Repair Procedure.
PARTS REQUIRED:
1
06032723
Screw, Door Panel Attaching