Intrepid V6-3.2L VIN J (1998)
Rear Door Panel: Service and Repair
REMOVAL
CAUTION: Do not pry on door trim panel, damage to trim panel will result.
1. Remove trim plug from the remote bezel by inserting a small flat blade tool into the notch and remove, if equipped.
2. Remove screw in the pull cup.
3. Remove screw in remote bezel.
4. Remove three screws from the bottom edge of door.
5. Using an trim tool, disengage the retaining clips from the door trim panel to the door panel. Two clips at the rear of panel and one at the front of
the panel.
6. Raise trim panel up over the door flange and being careful to hold the panel securely
7. Disconnect the remote linkage from the door remote handle.
8. Remove the wire connect from the rear door speaker.
9. Disconnect power window switch wire connector.
10. Disconnect wiring harness clips from the trim panel.
11. Disconnect the courtesy lamp.
12. Remove trim panel from door.
INSTALLATION
1. Place trim panel in position on the door.
2. Connect the courtesy lamp.
3. Connect the wiring harness clips to the trim panel.
4. Connect the power window switch wire harness connector.
5. Connect the rear door speaker wire connect.
