Intrepid V6-3.2L VIN J (1998)
5.
Remove the drive block screws from both of the lower track assemblies with a T-50 Torx bit and discard the screws (Fig. 1).
6.
Install revised drive block screws, p/n 05080982AA, into both drive blocks and finger tighten.
NOTE:
PLACE FINGER THROUGH THE RECTANGULAR HOLE IN THE UPPER TRACK TO HOLD THE DRIVE BLOCK IN PLACE WHILE
TIGHTENING THE SCREWS.
7.
Torque the revised drive block screws to 36-38 Nm (315-335 in. lbs.).
8.
Install the seat assembly into the vehicle and connect the wire harness connector(s).
9.
Adjust seat to the full rear position and install two (2) front attaching bolts, torque the bolts to 70 Nm (620 in. lbs.).
10.
If bench seat equipped, position the seat belt attachment bracket over the rear inboard mounting foot.
11.
Install the two (2) rear attaching bolts, torque the bolts to 70 Nm (620 in. lbs.).
12.
If the vehicle is Side Air Bag (SAB) equipped, connect a DRBIII(R) to the data link connector located at the lower edge of the instrument panel on
the left side of the steering column.
13.
Turn the ignition key to the ON position and exit the vehicle with the DRBIII(R).
14.
Connect the negative battery cable remote terminal.
15.
Use the DRBIII(R) to erase all air bag Diagnostic Trouble Codes (DTCs).
16.
If DTC(s) will not erase, refer to the proper Body Diagnostic Procedures Manual to diagnose the remaining DTC(s).
17.
Sit in the seat and cycle the seat through all positions.
18.
Set the clock to the correct time.
POLICY:
Reimbursable within the provisions of the warranty.
